Accéder au contenu
Merck

Chemical hazards present in liquids and vapors of electronic cigarettes.

Archives of toxicology (2014-06-25)
Christoph Hutzler, Meike Paschke, Svetlana Kruschinski, Frank Henkler, Jürgen Hahn, Andreas Luch
RÉSUMÉ

Electronic (e-)cigarettes have emerged in recent years as putative alternative to conventional tobacco cigarettes. These products do not contain typical carcinogens that are present in tobacco smoke, due to the lack of combustion. However, besides nicotine, hazards can also arise from other constituents of liquids, such as solvents, flavors, additives and contaminants. In this study, we have analyzed 28 liquids of seven manufacturers purchased in Germany. We confirm the presence of a wide range of flavors to enhance palatability. Although glycerol and propylene glycol were detected in all samples, these solvents had been replaced by ethylene glycol as dominant compound in five products. Ethylene glycol is associated with markedly enhanced toxicological hazards when compared to conventionally used glycerol and propylene glycol. Additional additives, such as coumarin and acetamide, that raise concerns for human health were detected in certain samples. Ten out of 28 products had been declared "free-of-nicotine" by the manufacturer. Among these ten, seven liquids were identified containing nicotine in the range of 0.1-15 µg/ml. This suggests that "carry over" of ingredients may occur during the production of cartridges. We have further analyzed the formation of carbonylic compounds in one widely distributed nicotine-free brand. Significant amounts of formaldehyde, acetaldehyde and propionaldehyde were only found at 150 °C by headspace GC-MS analysis. In addition, an enhanced formation of aldehydes was found in defined puff fractions, using an adopted machine smoking protocol. However, this effect was delayed and only observed during the last third of the smoking procedure. In the emissions of these fractions, which represent up to 40 % of total vapor volume, similar levels of formaldehyde were detected when compared to conventional tobacco cigarettes. By contrast, carbonylic compounds were hardly detectable in earlier collected fractions. Our data demonstrate the necessity of standardized machine smoking protocols to reliably address putative risks of e-cigarettes for consumers.

MATÉRIAUX
Référence du produit
Marque
Description du produit

Sigma-Aldrich
Méthanol, suitable for HPLC, ≥99.9%
Sigma-Aldrich
Dichlorométhane, suitable for HPLC, ≥99.8%, contains amylene as stabilizer
Sigma-Aldrich
Méthanol, ACS reagent, ≥99.8%
Sigma-Aldrich
Hydroxyde d′ammonium solution, ACS reagent, 28.0-30.0% NH3 basis
Sigma-Aldrich
Hydroxyde de sodium, ACS reagent, ≥97.0%, pellets
Sigma-Aldrich
Dichlorométhane, contains 40-150 ppm amylene as stabilizer, ACS reagent, ≥99.5%
Sigma-Aldrich
Hydroxyde de sodium, reagent grade, ≥98%, pellets (anhydrous)
Sigma-Aldrich
Hydroxyde de sodium solution, 50% in H2O
Sigma-Aldrich
Méthanol, HPLC Plus, ≥99.9%
Sigma-Aldrich
Dichlorométhane, HPLC Plus, for HPLC, GC, and residue analysis, ≥99.9%, contains 50-150 ppm amylene as stabilizer
Sigma-Aldrich
Hydroxyde d′ammonium solution, 28% NH3 in H2O, ≥99.99% trace metals basis
Sigma-Aldrich
Hydroxyde de sodium solution, BioUltra, for molecular biology, 10 M in H2O
Sigma-Aldrich
Chlorure de sodium, for molecular biology, DNase, RNase, and protease, none detected, ≥99% (titration)
Sigma-Aldrich
Méthanol, suitable for HPLC, gradient grade, suitable as ACS-grade LC reagent, ≥99.9%
Sigma-Aldrich
Hexane, Laboratory Reagent, ≥95%
Sigma-Aldrich
Chlorure de sodium solution, 5 M in H2O, BioReagent, for molecular biology, suitable for cell culture
Sigma-Aldrich
Hydroxyde de sodium solution, 1.0 N, BioReagent, suitable for cell culture
Sigma-Aldrich
Hydroxyde de sodium, BioXtra, ≥98% (acidimetric), pellets (anhydrous)
Sigma-Aldrich
Chlorure de sodium solution, 0.9% in water, BioXtra, suitable for cell culture
Sigma-Aldrich
Hydroxyde de sodium, reagent grade, 97%, powder
Sigma-Aldrich
Chlorure de sodium, BioReagent, suitable for cell culture, suitable for insect cell culture, suitable for plant cell culture, ≥99%
Sigma-Aldrich
Dichlorométhane, ACS reagent, ≥99.5%, contains 40-150 ppm amylene as stabilizer
Sigma-Aldrich
Méthanol, Laboratory Reagent, ≥99.6%
Sigma-Aldrich
Hydroxyde de sodium, puriss., meets analytical specification of Ph. Eur., BP, NF, E524, 98-100.5%, pellets
Sigma-Aldrich
Hydroxyde de sodium, pellets, semiconductor grade, 99.99% trace metals basis
Sigma-Aldrich
Chlorure de sodium, BioXtra, ≥99.5% (AT)
Sigma-Aldrich
Hydroxyde de sodium solution, 5.0 M
Sigma-Aldrich
Méthanol, BioReagent, ≥99.93%
Sigma-Aldrich
Méthanol, Absolute - Acetone free
SAFC
Chlorure de sodium solution, 5 M