コンテンツへスキップ
Merck

Fungal accumulation of metals from building materials during brown rot wood decay.

Archives of microbiology (2014-05-27)
Anne Christine Steenkjær Hastrup, Bo Jensen, Jody Jellison
要旨

This study analyzes the accumulation and translocation of metal ions in wood during the degradation performed by one strain of each of the three brown rot fungi; Serpula lacrymans, Meruliporia incrassata and Coniophora puteana. These fungi species are inhabitants of the built environment where the prevention and understanding of fungal decay is of high priority. This study focuses on the influence of various building materials in relation to fungal growth and metal uptake. Changes in the concentration of iron, manganese, calcium and copper ions in the decayed wood were analyzed by induced coupled plasma spectroscopy and related to wood weight loss and oxalic acid accumulation. Metal transport into the fungal inoculated wood was found to be dependent on the individual strain/species. The S. lacrymans strain caused a significant increase in total iron whereas the concentration of copper ions in the wood appeared decreased after 10 weeks of decay. Wood inoculated with the M. incrassata isolate showed the contrary tendency with high copper accumulation and low iron increase despite similar weight losses for the two strains. However, significantly lower oxalic acid accumulation was recorded in M. incrassata degraded wood. The addition of a building material resulted in increased weight loss in wood degraded by C. puteana in the soil-block test; however, this could not be directly linked specifically to the accumulation of any of the four metals recorded. The accumulation of oxalic acid seemed to influence the iron uptake. The study assessing the influence of the presence of soil and glass in the soil-block test revealed that soil contributed the majority of the metals for uptake by the fungi and contributed to increased weight loss. The varying uptake observed among the three brown rot fungi strains toward the four metals analyzed may be related to the specific non-enzymatic and enzymatic properties including bio-chelators employed by each of the species during wood decay.

材料
製品番号
ブランド
製品内容

Sigma-Aldrich
シュウ酸ナトリウム, ACS reagent, ≥99.5%
Sigma-Aldrich
シュウ酸, 98%
Sigma-Aldrich
シュウ酸, ReagentPlus®, ≥99%
Sigma-Aldrich
銅, powder, 99.999% trace metals basis
Sigma-Aldrich
銅, foil, thickness 0.25 mm, 99.98% trace metals basis
Sigma-Aldrich
シュウ酸ナトリウム, puriss. p.a., ACS reagent, ≥99.5% (RT)
Sigma-Aldrich
銅, powder, <425 μm, 99.5% trace metals basis
Sigma-Aldrich
マンガン, powder, ≥99.9% trace metals basis
Sigma-Aldrich
銅, wire, diam. 1.0 mm, ≥99.9%
Sigma-Aldrich
シュウ酸, purified grade, 99.999% trace metals basis
Sigma-Aldrich
銅, powder, <75 μm, 99%
Sigma-Aldrich
銅, nanopowder, 40-60 nm particle size (SAXS), ≥99.5% trace metals basis
Sigma-Aldrich
銅, powder (spheroidal), 10-25 μm, 98%
Sigma-Aldrich
シュウ酸ナトリウム, ≥99.99% trace metals basis
Sigma-Aldrich
銅, wire, diam. 0.25 mm, 99.999% trace metals basis
Sigma-Aldrich
マンガン, powder, −325 mesh, ≥99% trace metals basis
Sigma-Aldrich
シュウ酸ナトリウム, BioXtra
Sigma-Aldrich
銅, foil, thickness 0.025 mm, 99.98% trace metals basis
Sigma-Aldrich
銅, nanopowder, 60-80 nm particle size (SAXS), ≥99.5% trace metals basis
Sigma-Aldrich
銅, turnings, purum p.a., ≥99.0%
Sigma-Aldrich
銅, foil, ≥99.8% (complexometric)
Sigma-Aldrich
銅, powder (dendritic), <45 μm, 99.7% trace metals basis
Sigma-Aldrich
銅, wire, diam. 0.64 mm, 99.995% trace metals basis
Sigma-Aldrich
銅, foil, thickness 0.5 mm, 99.98% trace metals basis
Sigma-Aldrich
シュウ酸ナトリウム 溶液, 0.0125 M
Sigma-Aldrich
銅, shot, −3-+14 mesh, 99%
Sigma-Aldrich
シュウ酸, puriss. p.a., anhydrous, ≥99.0% (RT)
Sigma-Aldrich
銅, foil, thickness 1.0 mm, 99.999% trace metals basis
Sigma-Aldrich
マンガン, chips, thickness <2.0 mm, 99%
銅, mesh, 100x100mm, nominal aperture 0.14mm, thickness 0.25mm, wire diameter 0.115mm, 100x100 wires/inch, open area 30.3%, plain weave mesh