Saltar al contenido
Merck

Influence of pesticide use in fruit orchards during blooming on honeybee mortality in 4 experimental apiaries.

The Science of the total environment (2015-09-24)
Pau Calatayud-Vernich, Fernando Calatayud, Enrique Simó, Maria Morales Suarez-Varela, Yolanda Picó
RESUMEN

Samples of dead honey bees (Apis mellifera L.) were collected periodically from 4 different locations during citrus and stone fruit trees blooming season to evaluate the potential impact of agrochemicals on honey bee death rate. For the determination of mortality, dead honey bee traps were placed in front of the experimental hives entrance located in areas of intensive agriculture in Valencian Community (Spain). A total of 34 bee samples, obtained along the monitoring period, were analyzed by means of QuEChERS extraction method and screened for 58 pesticides or their degradation products by LC-MS/MS. An average of four pesticides per honey bee sample was detected. Coumaphos, an organophosphate acaricide used against varroosis in the experimental hives, was detected in 94% of the samples. However, this acaricide was unlikely to be responsible for honey bee mortality because its constantly low concentration during all the monitoring period, even before and after acute mortality episodes. The organophosphates chlorpyrifos and dimethoate, as well as the neonicotinoid imidacloprid, were the most frequently detected agrochemicals. Almost 80% of the samples had chlorpyrifos, 68% dimethoate, and 32% imidacloprid. Maximum concentrations for these three compounds were 751, 403, 223 ng/g respectively. Influence of these pesticides on acute honey bee mortality was demonstrated by comparing coincidence between death rate and concentrations of chlorpyrifos, dimethoate and imidacloprid.

MATERIALES
Referencia del producto
Marca
Descripción del producto

Sigma-Aldrich
Hidróxido de sodio, ACS reagent, ≥97.0%, pellets
Sigma-Aldrich
N,N-Dimetilformamida, ACS reagent, ≥99.8%
Sigma-Aldrich
Hidróxido de sodio, reagent grade, ≥98%, pellets (anhydrous)
Sigma-Aldrich
Ácido fórmico, reagent grade, ≥95%
Sigma-Aldrich
Hidróxido de sodio solution, 50% in H2O
Sigma-Aldrich
Sulfato de magnesio, anhydrous, ReagentPlus®, ≥99.5%
Sigma-Aldrich
Ácido fórmico, ACS reagent, ≥96%
Sigma-Aldrich
Acetonitrilo, ACS reagent, ≥99.5%
Sigma-Aldrich
Acetonitrilo, anhydrous, 99.8%
Sigma-Aldrich
Hidróxido de sodio solution, BioUltra, for molecular biology, 10 M in H2O
Sigma-Aldrich
Formato de amonio, reagent grade, 97%
Sigma-Aldrich
N,N-Dimetilformamida, anhydrous, 99.8%
Sigma-Aldrich
Cloruro de sodio, for molecular biology, DNase, RNase, and protease, none detected, ≥99% (titration)
Sigma-Aldrich
Sulfato de magnesio, anhydrous, reagent grade, ≥97%
Sigma-Aldrich
Sodium chloride solution, 5 M in H2O, BioReagent, for molecular biology, suitable for cell culture
Sigma-Aldrich
Hidróxido de sodio solution, 1.0 N, BioReagent, suitable for cell culture
Sigma-Aldrich
Hidróxido de sodio, BioXtra, ≥98% (acidimetric), pellets (anhydrous)
Sigma-Aldrich
Sodium chloride solution, 0.9% in water, BioXtra, suitable for cell culture
Sigma-Aldrich
Hidróxido de sodio, puriss. p.a., ACS reagent, reag. Ph. Eur., K ≤0.02%, ≥98%, pellets
Sigma-Aldrich
Cloruro de sodio, BioReagent, suitable for cell culture, suitable for insect cell culture, suitable for plant cell culture, ≥99%
Sigma-Aldrich
Hidróxido de sodio, reagent grade, 97%, powder
Sigma-Aldrich
Hidróxido de sodio, puriss., meets analytical specification of Ph. Eur., BP, NF, E524, 98-100.5%, pellets
Sigma-Aldrich
N,N-Dimetilformamida, puriss. p.a., ACS reagent, reag. Ph. Eur., ≥99.8% (GC)
Sigma-Aldrich
Formato de amonio, ≥99.995% trace metals basis
Sigma-Aldrich
Ácido fórmico, ACS reagent, ≥88%
Sigma-Aldrich
N,N-Dimetilformamida, ReagentPlus®, ≥99%
Sigma-Aldrich
Hidróxido de sodio, pellets, semiconductor grade, 99.99% trace metals basis
Sigma-Aldrich
N,N-Dimetilformamida, for molecular biology, ≥99%
Sigma-Aldrich
Sulfato de magnesio, anhydrous, free-flowing, Redi-Dri, ReagentPlus®, ≥99.5%
SAFC
Sodium chloride solution, 5 M