Passa al contenuto
Merck
  • Development of high energy density supercapacitor through hydrothermal synthesis of RGO/nano-structured cobalt sulphide composites.

Development of high energy density supercapacitor through hydrothermal synthesis of RGO/nano-structured cobalt sulphide composites.

Nanotechnology (2015-02-03)
Milan Jana, Sanjit Saha, Pranab Samanta, Naresh Chandra Murmu, Nam Hoon Kim, Tapas Kuila, Joong Hee Lee
ABSTRACT

Co9S8/reduced graphene oxide (RGO) composites were prepared on nickel foam substrate through hydrothermal reaction and used directly as supercapacitor electrode. The field emission scanning electron microscopy analysis of the composites showed the formation of Co9S8 nano-rods on the RGO surfaces. The average crystal size of the Co9S8 nano rods grown on the RGO sheets were ∼25-36 nm as calculated from x-ray diffraction analysis. The reduction of graphene oxide (GO) was confirmed by Raman and x-ray photoelectron spectroscopy analysis. The electrical conductivity of the Co9S8/RGO composite was recorded as 1690 S m(-1) at room temperature, which is much higher than that of pure GO further confirming the hydrothermal reduction of GO. Cyclic voltammetry, galvanostatic charge-discharge and electrochemical impedance spectroscopy were investigated to check the electrochemical performances of the Co9S8/RGO composites. The Co9S8/RGO composites supported on nickel foam showed very high specific capacitance (Sc)(1349 F g(-1) at a current density of 2.2 A g(-1)), energy density (68.6 W h kg(-1)) and power density (1319 W kg(-1)) in 6 M KOH electrolyte. The retention in Sc of the composite electrode was found to be ∼96% after 1000 charge-discharge cycles.

MATERIALI
N° Catalogo
Marchio
Descrizione del prodotto

Sigma-Aldrich
Acido cloridrico, ACS reagent, 37%
Sigma-Aldrich
Acido solforico, ACS reagent, 95.0-98.0%
Sigma-Aldrich
Perossido di idrogeno, contains inhibitor, 30 wt. % in H2O, ACS reagent
Sigma-Aldrich
Idrossido di potassio, ACS reagent, ≥85%, pellets
Sigma-Aldrich
Acido cloridrico, ACS reagent, 37%
Sigma-Aldrich
Perossido di idrogeno, 30 % (w/w) in H2O, contains stabilizer
Sigma-Aldrich
Cloruro di idrogeno, 4.0 M in dioxane
Sigma-Aldrich
Idrossido di potassio, reagent grade, 90%, flakes
Sigma-Aldrich
Potassium permanganate, ACS reagent, ≥99.0%
Sigma-Aldrich
Acido cloridrico, 1.0 N, BioReagent, suitable for cell culture
Sigma-Aldrich
Perossido di idrogeno, 50 wt. % in H2O, stabilized
Sigma-Aldrich
Potassium hydroxide solution, 45 wt. % in H2O
Sigma-Aldrich
Acido solforico, 99.999%
Sigma-Aldrich
Acido cloridrico, 37 wt. % in H2O, 99.999% trace metals basis
Sigma-Aldrich
Idrossido di potassio, semiconductor grade, pellets, 99.99% trace metals basis (Purity excludes sodium content.)
Sigma-Aldrich
Acido cloridrico, 36.5-38.0%, BioReagent, for molecular biology
Supelco
Potassium hydroxide solution, volumetric, 8.0 M KOH (8.0N)
Sigma-Aldrich
Cloruro di idrogeno, 2.0 M in diethyl ether
Supelco
Acido cloridrico, volumetric, 0.1 M HCl (0.1N), endotoxin free
Sigma-Aldrich
Idrossido di potassio, ≥85% KOH basis, pellets, white
Sigma-Aldrich
Idrossido di potassio, BioXtra, ≥85% KOH basis
Sigma-Aldrich
Idrossido di potassio, technical, ≥85%, powder
Sigma-Aldrich
Perossido di idrogeno, contains inhibitor, 35 wt. % in H2O
Sigma-Aldrich
Potassium permanganate, ACS reagent, ≥99.0%, low in mercury
Sigma-Aldrich
Cloruro di idrogeno, 1.0 M in diethyl ether
Sigma-Aldrich
Potassium permanganate, ≤150 μm particle size, 97%
Sigma-Aldrich
Idrossido di potassio, anhydrous, ≥99.95% trace metals basis
Sigma-Aldrich
Acido cloridrico, ~6 M in H2O, for amino acid analysis
Sigma-Aldrich
Cloruro di idrogeno, 3 M in cyclopentyl methyl ether (CPME)
Sigma-Aldrich
Acido cloridrico, 32 wt. % in H2O, FCC