MPHL04GH2

Capsule Millipak^® con membrana Durapore^® da 0,45 µm

Millipak^® 40, sterile

• Sinonimo/i: Sterile Millipak-40 Filter Unit 0.45 μm 1/4 in. HB/HB w/bell
• Codice UNSPSC: 23151806
• eCl@ss: 32031690
• NACRES: NB.24

Proprietà

• Materiali: PVDF membrane; PVDF vent cap; polycarbonate ; polycarbonate support
• Livello qualitativo: 400
• Sterilità: irradiated; sterile
• Nome Commerciale: Millipak^® 40
• Caratteristiche: hydrophilic
• Produttore/marchio commerciale: Millipak^®
• Parametri: 0.35 bar max. differential pressure (5 psid) at 123 °C (Forward); 0.7 bar max. differential pressure (10 psid) at 25 °C (Reverse); 1.7 bar max. differential pressure (25 psid) at 80 °C (Forward); 4.1 bar max. differential pressure (60 psid) at 25 °C (Forward); 5.2 bar max. inlet pressure (75 psi); 8.5 L/min flow rate at 2.45 bar (ΔP)
• tecniche: bioburden reduction: suitable
• Superficie filtrante: 200 cm²
• Diam. connessione ingresso: 1/4 in.
• Diam. connessione uscita: 1/4 in.
• Impurezze: ≤0.5 EU/mL (LAL test, Aqueous extraction); <0.5 EU/mL USP bacterial endotoxins (LAL test, sample aqueous extraction)
• Estraibili (gravimetria): ≤1.5 mg/device
• Matrice: Durapore^®
• Dimensione pori: 0.45 μm
• Punto di bolla: ≥1790 mbar (26 psig), air with water at 23 °C
• Raccordi: inlet hose barb; outlet hose barb (with bell); (6 mm (1/4 in.) Hose Barb Inlet and Outlet with filling bell)
• Condizioni di spedizione: ambient

Descrizione

Descrizione generale

Device Configuration: Gamma Gold Capsule

Confezionamento

Blister

Altre note

These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.

Directions for Use

• Organism Retention: Microorganism
• Mode of Action: Filtration (size exclusion)
• Application: BioProcessing
• Intended Use: Reduction or removal of microorganism/bioburden
• Instructions for Use: Please refer Wetting Instructions for Filter Units with Durapore^® Membrane user guide
• Storage Statement: Store in dry location
• Disposal Statement: Dispose of in accordance with applicable federal, state and local regulations.

Nota sulla preparazione

Sterilization Method
3 autoclave cycles of 90 min @ 123 °C; not in-line steam sterilizable

This product was manufactured with a Durapore^® membrane which meets the criteria for a "non-fiber releasing" filter as defined in 21 CFR 210.3 (b) (6).

Risultati analitici

Gravimetric Extractables: using sterilized device after a 200 mL flush and 24 hours in water at controlled room temperature

Will meet the USP Oxidizable Substances Test requirements after a water flush of ≥200 mL

Note legali

Durapore is a registered trademark of Merck KGaA, Darmstadt, Germany

MILLIPAK is a registered trademark of Merck KGaA, Darmstadt, Germany