콘텐츠로 건너뛰기
Merck
모든 사진(2)

주요 문서

모든 문서 보기

S6322

Sigma-Aldrich

Sigma Adjuvant System®

oil

동의어(들):

Adjuvant System, Sigma Adjuvant

로그인조직 및 계약 가격 보기

크기 선택

1 VIAL
₩355,656

₩355,656

예상 입고일2025년 4월 14일세부사항

벌크 견적 요청
모든 사진(2)

크기 선택

보기 변경
1 VIAL
₩355,656

About This Item

UNSPSC 코드:
12352203
NACRES:
NA.46

₩355,656

예상 입고일2025년 4월 14일세부사항

벌크 견적 요청

양식

oil

Quality Level

300

저장 온도

2-8°C

애플리케이션

Adjuvanticity Assay: EIA titer for test mice is at least 2X greater that that of control mice.

생화학적/생리학적 작용

Sigma Adjuvant System is a stable oil-in-water emulsion that may be used as an alternative to the classical Freund′s water-in-oil emulsions. It is derived from bacterial and mycobacterial cell wall components that provide potent stimulus to the immune system.

물리적 형태

Each vial contains 0.5 mg Monophosphoryl Lipid A (detoxified endotoxin) from Salmonella minnesota and 0.5 mg synthetic Trehalose Dicorynomycolate in 2% oil (squalene)-Tween® 80-water.

법적 정보

Sigma Adjuvant System is a registered trademark of Merck KGaA, Darmstadt, Germany
TWEEN is a registered trademark of Croda International PLC

면책조항

Unless otherwise stated in our catalog or other company documentation accompanying the product(s), our products are intended for research use only and are not to be used for any other purpose, which includes but is not limited to, unauthorized commercial uses, in vitro diagnostic uses, ex vivo or in vivo therapeutic uses or any type of consumption or application to humans or animals.

관련 제품

제품 번호
설명
가격

08168

Timestrip Plus™ 8 °C

픽토그램

Health hazard
GHS08

신호어

Danger

유해 및 위험 성명서

H304

예방조치 성명서

P301 + P310 - P331 - P405 - P501

Hazard Classifications

Asp. Tox. 1

Storage Class Code

10 - Combustible liquids

WGK

WGK 2

Flash Point (°F)

Not applicable

Flash Point (°C)

Not applicable

개인 보호 장비

Eyeshields, Gloves, multi-purpose combination respirator cartridge (US)

가장 최신 버전 중 하나를 선택하세요:

시험 성적서(COA)

Lot/Batch Number
0000407553
0000407553
0000329924
0000235360
0000235360

적합한 버전을 찾을 수 없으신가요?

특정 버전이 필요한 경우 로트 번호나 배치 번호로 특정 인증서를 찾을 수 있습니다.

COA 검색

이 제품을 이미 가지고 계십니까?

문서 라이브러리에서 최근에 구매한 제품에 대한 문서를 찾아보세요.

문서 라이브러리 방문

Development of monoclonal antibodies specific for Ricinus agglutinins
Brandon DL and Hernlem BJ
Food and agricultural immunology, 20(1), 11-22 (2009)
Déirdre B Ní Eidhin et al.
FEMS immunology and medical microbiology, 52(2), 207-218 (2007-12-21)
Clostridium difficile is the leading cause of infectious antibiotic-associated diarrhoea, particularly among the elderly. Its surface-layer protein (SLP) was tested as a vaccine component in a series of immunization and challenge experiments with Golden Syrian hamsters, combined with different systemic
Avi-Hai Hovav et al.
Infection and immunity, 73(1), 250-257 (2004-12-25)
In this study, we examined the immunogenicity and protective efficacy of six immunodominant Mycobacterium tuberculosis recombinant antigens (85B, 38kDa, ESAT-6, CFP21, Mtb8.4, and 16kDa) in a multivalent vaccine preparation (6Ag). Gamma interferon (IFN-gamma) and monophosphoryl lipid A-trehalose dicorynomycolate (Ribi) adjuvant
Nadja Thönes et al.
Journal of virology, 82(11), 5472-5485 (2008-04-04)
Capsomeres are considered to be an alternative to viruslike particle (VLP)-based vaccines as they can be produced in prokaryotic expression systems. So far, no detailed side-by-side comparison of VLPs and capsomeres has been performed. In the present study, we immunized
Amanda L Gavin et al.
Science (New York, N.Y.), 314(5807), 1936-1938 (2006-12-23)
Innate immune signals mediated by Toll-like receptors (TLRs) have been thought to contribute considerably to the antibody-enhancing effects of vaccine adjuvants. However, we report here that mice deficient in the critical signaling components for TLR mount robust antibody responses to
모든 관련된 서류 보기

문서

An Introduction to Antibodies: Antigens, Epitopes and Antibodies

Antibodies combine with specific antigens to generate an exclusive antibody-antigen complex. Learn about the nature of this bond and its use as a molecular tag for research.

관련 콘텐츠

Antibody Support Reagents

Access high-quality reagents for antibody workflows, including adjuvants, blocking reagents, conjugation kits, and more.

질문

1–8 / 8 질문  

  1. Is the adjuvant ready to use? I don't see any mention in the datasheet on how to prepare the Antigen:adjuvant mixture. Can you help with that? Thank you.

    1 답변

    1. This product requires dilution with saline prior to use. This dilution can be done with or without the addition of the antigen. See below for a brief protocol.

      Prior to antigen addition, warm contents of vial to 40-45 °C. Add 2.0 mL of sterile saline containing the desired amount of antigen.
      The final emulsion will contain a concentration of 2% oil.
      1. Inject antigen-saline solution (2 mL) directly into the vial through the rubber stopper using a syringe fitted with a 20 or 21-gauge needle (leave the cap seal in place).
      2. Vortex the vial vigorously for 2 to 3 minutes to form emulsion. Invert the vial and vortex for 1 minute to ensure reconstitution of any product adhering to the stopper.
      3. If the entire contents of the vial will not be used initially, reconstitute with 1 ml saline without antigen. This emulsion can be stored at 2-8 °C for up to 60 days. Do Not freeze.
      To use, mix aliquots 1:1 with antigen in saline.
      4. Prior to inoculation, warm the vial to 37 °C and vortex briefly.

      For full details on injection protocols and boosting, please navigate to the link https://www.sigmaaldrich.com/techservice, click on "Product Technical Inquiries" under the Products Section with all the required information so that a member of the Technical Service team can reach out to assist further. Thank you.

      도움이 되었습니까?

  2. What is the Department of Transportation shipping information for this product?

    1 답변

    1. Transportation information can be found in Section 14 of the product's (M)SDS.To access the shipping information for this material, use the link on the product detail page for the product.

      도움이 되었습니까?

  3. When using the Sigma Adjuvant System® reagent, Product No. S6322, how do the components MPL and TDM work as an adjuvant?

    1 답변

    1. MPL (monophosphoryl lipid A) will bind to CD14 on the cell surface similar to LPS.  TDM (trehalose dicorynomycolate) is an analog of one of the components of the tubercle bacillus. Both of these components act like a superantigen and activate the immune system nonspecifically.  This allows for a greater response to the immunogen delivered in this adjuvant.

      도움이 되었습니까?

  4. Can you reconstitute and store the Sigma Adjuvant System® reagent (Product No. S6322) if not using the entire vial right away?

    1 답변

    1. If the entire contents of the vial will not be used initially, reconstitute with 1 ml saline without antigen.  This emulsion can then be stored at 2-8 °C for up to 60 days.  Do Not Freeze. To use, mix aliquots 1:1 with antigen in saline. Prior to inoculation, warm the vial to 37 °C and vortex briefly.  This and other information can be found on the Sigma Adjuvant System® reagent (Product No. S6322) Product Information Sheet.

      도움이 되었습니까?

  5. What is used to solubilize Product No. S6322, Sigma Adjuvant System® reagent?

    1 답변

    1. The Sigma Adjuvant System® reagent (Product No. S6322) can be solubilized in a sterile saline solution containing the desired amount of antigen to a final volume of 2 ml.  For more details, please see the S6322 Product Information Sheet.

      도움이 되었습니까?

  6. Is the Sigma Adjuvant System®, Product No S6322, the same as the RIBI adjuvant?

    1 답변

    1. Yes, the Sigma Adjuvant System®, Product No S6322, is also called RIBI adjuvant.

      도움이 되었습니까?

  7. Has Sigma Adjuvant System®, Product S6322, been used to induce EAE (Experimental autoimmune encephalomyelitis)?

    1 답변

    1. Sigma Adjuvant System®, Product S6322 is a replacement for MPT+TDM adjuvant (Ribi, Product M6536) that was discontinued by the supplier Corixa.  Although we have not tested Product S6322 for induction of Experimental autoimmune encephalomyelitis (EAE), the following reference cites the use of MBP in Ribi adjuvant for induction of acute EAE.The Journal of ImmunologyOctober 15, 2005, 175(8): 5077-5086

      도움이 되었습니까?

  8. When using the Sigma Adjuvant System®, Product No. S6322, how is the antigenic response boosted?

    1 답변

    1. With the Sigma Adjuvant System® (Product No. S6322) with mice, rabbits, rats and guinea pigs; boost on day 21 or 28, bleed 10 - 14 days after booster injection. Boost every 3 - 4 weeks thereafter. For goats; boost every four weeks. Use the same protocol for each injection.  For more information please see the Product Information Sheet for Product No. S6322.

      도움이 되었습니까?

후기

평점 값 없음

활성 필터

자사의 과학자팀은 생명 과학, 재료 과학, 화학 합성, 크로마토그래피, 분석 및 기타 많은 영역을 포함한 모든 과학 분야에 경험이 있습니다..

고객지원팀으로 연락바랍니다.