推荐产品
材料
polyethersulfone membrane
polyethylene support
polypropylene (gamma-stable)
polypropylene housing
polypropylene vent cap
polysulfone
silicone seal
品質等級
無菌
irradiated
non-sterile
滅菌相容性
gamma compatible
產品線
Opticap® XL 300
特點
hydrophobic
製造商/商標名
Opticap®
參數
2.1 bar max. differential pressure (30 psid) at 25 °C (Reverse; intermittent)
25 °C max. inlet temp.
4.1 bar max. inlet pressure (60 psi) at 23 °C
4.2 bar max. differential pressure (60 psid) at 25 °C (Forward)
60 psi max. differential pressure (4.1 bar) (continuous)
60 psig max. inlet pressure
技術
gas filtration: suitable
長度
11.9 cm (4.7 in.)
直徑
5.6 cm (2.2 in.)
過濾面積
0.048 m2
入口接頭直徑
3/4 in.
入口到出口寬度
11.9 cm (4.7 in.)
出口接頭直徑
3/4 in.
雜質
≤0.25 EU/mL (LAL test, Aqueous extraction)
<0.25 EU/mL USP bacterial endotoxins (LAL test, sample aqueous extraction)
重量法萃取物
≤3 mg
基質
Millipore Express® SPG
孔徑
0.2 μm pore size
起泡點
≥1210 mbar (17.5 psig), air with 70/30% IPA/water at 23 °C
接頭
1/4 in. drain/vent hose barb (with double O-ring seal)
inlet sanitary flange
outlet sanitary flange
(19 mm (3/4 in.) Sanitary Flange Inlet and Outlet)
運輸包裝
ambient
正在寻找类似产品? 访问 产品对比指南
一般說明
包裝
其他說明
- Organism Retention: Microorganism
- Mode of Action: Filtration (size exclusion)
- Application: BioProcessing
- Intended Use: Reduction or removal of microorganism/bioburden
- Instructions for Use: Please refer Wetting Instructions for Filter Units with Durapore® Membrane user guide
- Storage Statement: Store in dry location
- Disposal Statement: Dispose of in accordance with applicable federal, state and local regulations.
準備報告
Gamma compatible to 45 kGy; 3 autoclave cycles of 60 min @ 123 °C; not in-line steam sterilizable
分析報告
Samples were quantitatively retentive of a minimum Brevundimonas diminuta challenge concentration of 1 x 10⁷ CFU/cm² using ASTM® F838 methodology.
After gamma irradiation and three autoclave cycles, the TOC was measured to be equal to or less than 3367 µg/device.
法律資訊
免責聲明
Not finding the right product?
Try our 产品选型工具.
我们的科学家团队拥有各种研究领域经验,包括生命科学、材料科学、化学合成、色谱、分析及许多其他领域.
联系技术服务部门