CGW173S48

Polysep^™ II 1.0/0.2/0.1 µm nominal, Cartridge

pore size 1.0/0.2/0.1 μm, cartridge nominal length 75 cm (30 in.)

• Code UNSPSC : 23151806

Propriétés

• Matériaux: borosilicate glass fiber (BGF) membrane; fluoroelastomer O-ring; mixed cellulose esters (MCE) membrane; polypropylene support
• Niveau de qualité: 400
• Conformité réglementaire: meets FDA 21 CFR 177-182 (all component materials)
• Stérilité: non-sterile
• Mode de stérilisation compatible: autoclavable compatible; steam-in-place compatible
• Gamme de produits: Polysep^™
• Caractéristiques: hydrophilic
• Fabricant/nom de marque: Polysep^™
• Technique(s): prefiltration: suitable
• Longueur: 30 in.
• Largeur: 2.7 in.
• Longueur nominale des cartouches: 75 cm (30 in.)
• Surface de filtration: 1.26 m²
• Matrice: Polysep^™ II
• pore size: 1.0/0.2/0.1 μm nominal pore size; 1.0/0.2/0.1 μm pore size
• Code de la cartouche: Code 7

Description

Description générale

Device Configuration: Cartridge

Caractéristiques et avantages

Triple Layer

Notes préparatoires

Non-Fiber Releasing: This product was manufactured with a media combination which meets the criteria for a "non-fiber releasing" filter as defined in 21CFR210.3(b)(6).

Remarque sur l'analyse

Gravimetric Extractables: the extractables level was equal to or less than 140 mg per 10-inch cartridge after 24 hours in water at controlled room temperature.

Autres remarques

Directions for Use

• Organism Retention: Microorganism
• Mode of Action: Filtration (size exclusion)
• Application: BioProcessing
• Intended Use: Reduction or removal of microorganism/bioburden
• Instructions for Use: Please refer first page of Visual Inspection Guide and introduction section of Mixed cellulose esters Tech Brief
• Storage Statement: Please refer Mixed cellulose esters Tech Brief
• Disposal Statement: Dispose of in accordance with applicable federal, state and local regulations

These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.

Informations légales

Polysep is a trademark of Sigma-Aldrich Co. LLC