Saltar al contenido
Merck

Experimental study on a room temperature urea-SCR of NO over activated carbon fibre-supported CeO2-CuO.

Environmental technology (2013-07-11)
Xiao Jiang, Pei Lu, Caiting Li, Zheng Zeng, Guangming Zeng, Luping Hu, Lei Mai, Zhi Li
RESUMEN

In order to establish a desirable method for NO reduction, selective catalytic reduction (SCR) of NO by urea-CeO2/ACF and urea-CeO2-CuO/ACF was carried out at room temperature. The experimental results showed that 10% urea-9% CeO2/ACF could yield the highest NO conversion of 85% among the series of urea-CeO2/ACF prepared. When urea-CeO2-CuO/ACF was compared with urea-CeO2/ACF, it achieved higher NO conversion to a certain degree with the addition of CuO, which was attributed to the synergistic effect between cerium and copper. The effect of the mass ratio of CeO2 and CuO was also observed. The desirable mass ratio of CeO2 and CuO was 1:1, which yielded about 90% NO conversion when ACF was loaded with 10% urea. Furthermore, the influence of O2 concentration and NO concentration was also observed. In this study, NO conversion increased with increasing O2 concentration. In addition, some samples were further characterized by BET, X-ray diffraction, X-ray photoelectron spectroscopy and Fourier transform infrared methods.

MATERIALES
Referencia del producto
Marca
Descripción del producto

Sigma-Aldrich
Urea, powder, BioReagent, for molecular biology, suitable for cell culture
Supelco
Urea, 8 M (after reconstitution with 16 mL high purity water)
Sigma-Aldrich
Urea solution, BioUltra, ~8 M in H2O
Sigma-Aldrich
Copper(II) oxide, nanopowder, <50 nm particle size (TEM)
Sigma-Aldrich
Copper(II) oxide, ACS reagent, ≥99.0%
Sigma-Aldrich
Copper(II) oxide, powder, <10 μm, 98%
Sigma-Aldrich
Urea, BioXtra, pH 7.5-9.5 (20 °C, 5 M in H2O)
Sigma-Aldrich
Copper, powder, 99.999% trace metals basis
Sigma-Aldrich
Copper, foil, thickness 0.25 mm, 99.98% trace metals basis
Sigma-Aldrich
Urea, BioUltra, for molecular biology, 99% (T)
Sigma-Aldrich
Urea, ACS reagent, 99.0-100.5%
Sigma-Aldrich
Cerium(IV) oxide, nanopowder, <25 nm particle size (BET)
Sigma-Aldrich
Copper, powder, <425 μm, 99.5% trace metals basis
Sigma-Aldrich
Cerium(IV) oxide, powder, <5 μm, 99.9% trace metals basis
Sigma-Aldrich
Copper, wire, diam. 1.0 mm, ≥99.9%
Sigma-Aldrich
Urea, suitable for electrophoresis
Sigma-Aldrich
Cerium(IV) oxide, ≥99.0%
Sigma-Aldrich
Cerium(IV) oxide, nanopowder, <50 nm particle size (BET), 99.95% trace rare earth metals basis
Sigma-Aldrich
Copper(II) oxide, powder, 99.99% trace metals basis
Sigma-Aldrich
Copper(II) oxide, needles, mixture of CuO and Cu2O, ACS reagent
Sigma-Aldrich
Copper, powder, <75 μm, 99%
Sigma-Aldrich
Copper, nanopowder, 40-60 nm particle size (SAXS), ≥99.5% trace metals basis
Sigma-Aldrich
Copper, powder (spheroidal), 10-25 μm, 98%
Sigma-Aldrich
Copper, wire, diam. 0.25 mm, 99.999% trace metals basis
Sigma-Aldrich
Copper, nanopowder, 60-80 nm particle size (SAXS), ≥99.5% trace metals basis
Sigma-Aldrich
Copper, foil, thickness 0.025 mm, 99.98% trace metals basis
Sigma-Aldrich
Cerium(IV) oxide, powder, 99.995% trace metals basis
Sigma-Aldrich
Urea, meets USP testing specifications
Sigma-Aldrich
Copper, turnings, purum p.a., ≥99.0%
Sigma-Aldrich
Cerium(IV) oxide, dispersion, nanoparticles, <25 nm particle size, 10 wt. % in H2O