SN12A47FF3

OptiScale^® Capsule Filter Polygard^® CN

filtration area 17.7 cm², pore size 1.2 μm

• Sinónimos: Optiscale Capsule Polygard -CN 1.2 μm 3/4 in. TC/TC, Optiscale^® Capsule Filter Polygard^® CN
• eCl@ss: 32031610
• UNSPSC Code: 23151806

Propiedades

• Nombre del producto: OptiScale^® 47 Capsule Media: Polygard^®-CN 1.2 µm Nominal, Max Pressure: 80 psi @ 25 °C
• Quality Segment: 400
• material: PVDF vent cap, fluoroelastomer FKM seal, polycarbonate , polypropylene , polypropylene support
• reg. compliance: meets FDA Indirect Food Additive requirements cited in 21 CFR 177-182 (all component materials)
• manufacturer/tradename: OptiScale^®
• parameter: 25 °C max. inlet temp., 5.5 bar max. inlet pressure (80 psi) at 25 °C, 80 psig max. inlet pressure
• diam.: 6.9 cm (2.7 in.)
• filtration area: 17.7 cm²
• inlet connection diam.: 3/4 in.
• outlet connection diam.: 3/4 in.
• impurities: ≤0.25 EU/mL bacterial endotoxins (LAL test, Aqueous extraction)
• matrix: Polygard^®-CN
• pore size: 1.2 μm nominal pore size, 1.2 μm pore size
• input: sample type liquid
• fitting: inlet sanitary flange, 19 mm (3/4 in.) inlet/outlet sanitary flange, outlet sanitary flange

Descripción

General description

Device Configuration: Capsule

Features and Benefits

Format: Single Layer

Preparation Note

Sterilization Method
3 autoclave cycles of 60 min @ 126 °C; not in-line steam sterilizable

Analysis Note

Will meet the USP Oxidizable Substances Test requirements after a water flush of ≥100 mL

Other Notes

Directions for Use:

• Organism Retention: Bacterial
• Mode of Action: Filtration (size exclusion)
• Appliication: Protein Purification
• Intended Use: Reduction or removal of microorganism/bioburden
• Instructions for Use: Please refer to the installation and wetting sections of OptiScale^® 47 Capsulle Filter with Polygard^® CN Media user guide
• Storage Statement: Store in original packaging at room temperature
• Disposal Statement: Dispose of in accordance with applicable federal, state, and local regulations

These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.

Legal Information

OptiScale is a registered trademark of Merck KGaA, Darmstadt, Germany

POLYGARD is a registered trademark of Merck KGaA, Darmstadt, Germany