CGW171S48

Polysep^™ II 1.0/0.2/0.1 µm nominal, Cartridge

pore size 1.0/0.2/0.1 μm, cartridge nominal length 25 cm (10 in.)

• UNSPSC-Code: 23151806

Eigenschaften

• Materialien: borosilicate glass fiber (BGF) membrane; fluoroelastomer O-ring; mixed cellulose esters (MCE) membrane; polypropylene support
• Qualitätsniveau: 400
• Einhaltung gesetzlicher Vorschriften: meets FDA 21 CFR 177-182 (all component materials)
• Sterilität: non-sterile
• Kompatibilität mit Sterilisationsverfahren: autoclavable compatible; steam-in-place compatible
• Produktlinie: Polysep^™
• Leistungsmerkmale: hydrophilic
• Hersteller/Markenname: Polysep^™
• Methode(n): prefiltration: suitable
• Länge: 10 in.
• Breite: 2.7 in.
• Nennlänge Kartusche: 25 cm (10 in.)
• Filtrationsfläche: 0.42 m²
• Matrix: Polysep^™ II
• pore size: 1.0/0.2/0.1 μm nominal pore size; 1.0/0.2/0.1 μm pore size
• Kartuschencode: Code 7

Beschreibung

Allgemeine Beschreibung

Device Configuration: Cartridge

Leistungsmerkmale und Vorteile

Triple Layer

Angaben zur Herstellung

Non-Fiber Releasing: This product was manufactured with a media combination which meets the criteria for a "non-fiber releasing" filter as defined in 21CFR210.3(b)(6).

Hinweis zur Analyse

Gravimetric Extractables: the extractables level was equal to or less than 140 mg per 10-inch cartridge after 24 hours in water at controlled room temperature.

Sonstige Hinweise

Directions for Use

• Organism Retention: Microorganism
• Mode of Action: Filtration (size exclusion)
• Application: BioProcessing
• Intended Use: Reduction or removal of microorganism/bioburden
• Instructions for Use: Please refer first page of Visual Inspection Guide and introduction section of Mixed cellulose esters Tech Brief
• Storage Statement: Please refer Mixed cellulose esters Tech Brief
• Disposal Statement: Dispose of in accordance with applicable federal, state and local regulations

These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.

Rechtliche Hinweise

Polysep is a trademark of Sigma-Aldrich Co. LLC