CWLC72S03

Milligard^® LPB 1.2/0.5 µm nominal, Cartridge

cartridge nominal length 20 in. (50 cm), filter diam. 2.8 in. (7.1 cm)

• Code UNSPSC : 23151806

Propriétés

• Matériaux: polyester support; polypropylene device; silicone seal
• Niveau de qualité: 400
• Stérilité: non-sterile
• Mode de stérilisation compatible: autoclavable compatible; steam-in-place compatible
• Gamme de produits: Milligard^®
• Caractéristiques: hydrophilic
• Fabricant/nom de marque: Milligard^®
• Paramètres: 3.5 bar max. differential pressure (50 psid) at 25 °C; 3.5 bar max. inlet pressure (50 psi) at 25 °C
• Technique(s): prefiltration: suitable
• Longueur: 20 in.
• Largeur: 2.9 in.
• Longueur nominale des cartouches: 20 in. (50 cm)
• Diam. du filtre: 2.8 in. (7.1 cm)
• Taille du filtre: 20 in.
• Surface de filtration: 1.4 m²
• Impuretés: ≤0.5 EU/mL bacterial endotoxins (LAL test, aqueous extraction); <0.5 EU/mL USP bacterial endotoxins (LAL test, sample aqueous extraction)
• Matrice: Milligard^® LPB
• pore size: 1.2/0.5 μm nominal pore size; 1.2/0.5 μm pore size
• Code de la cartouche: Code 7

Description

Description générale

Cartridge Type: Liquid

Device Configuration: Cartridge

Filter Grade: Low Protein Binding MILLIGARD^® Media

Caractéristiques et avantages

Format: Double Layer

Conditionnement

Double Easy-Open bag

Notes préparatoires

Sterilization Method: 10 autoclave cycles or SIP at 121 °C for 30 min

This product was manufactured with a media combination which meets the criteria for a "non-fiber releasing" filter as defined in 21 CFR 210.3 (b) (6).

Remarque sur l'analyse

Gravimetric Extractables: The extractables level was ≤350 mg per 10-inch cartridge after a 5 L flush and 24 hours in water at controlled room temperature.

Will meet the USP Oxidizable Substances Test requirements after a water flush of ≥6 L  

Autres remarques

Directions for Use:

• Organism Retention: Microorganism
• Mode of Action: Filtration (size exclusion)
• Application: BioProcessing
• Intended Use: Reduction or removal of microorganism/bioburden
• Instructions for Use: Please refer installation and wetting sections of OPTISCALE^® -25 user guide and introduction section of Mixed cellulose esters Tech Brief
• Storage Statement: Please refer Mixed cellulose esters Tech Brief
• Disposal Statement: Dispose of in accordance with applicable federal, state and local regulations

These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.

Informations légales

MILLIGARD is a registered trademark of Merck KGaA, Darmstadt, Germany

OptiScale is a registered trademark of Merck KGaA, Darmstadt, Germany