Saltar al contenido
MilliporeSigma

Highly charged cellulose-based nanocrystals as flocculants for harvesting Chlorella vulgaris.

Bioresource technology (2015-07-27)
Dries Vandamme, Samuel Eyley, Guy Van den Mooter, Koenraad Muylaert, Wim Thielemans
RESUMEN

This study presents a novel flocculant for harvesting Chlorella vulgaris as model species for freshwater microalgae based on cellulose nanocrystals (CNCs), thus synthesized from a renewable and biodegradable resource. Cationic pyridinium groups were grafted onto CNCs by two separate one-pot simultaneous esterification and nucleophilic substitution reactions. Both types of modified CNCs were positively charged in the pH range 4-11. Both reactions yielded CNCs with a high degree of substitution (up to 0.38). A maximum flocculation efficiency of 100% was achieved at a dosage of 0.1 g g(-1) biomass. In contrast to conventional polymer flocculants, cationic CNCs were relatively insensitive to inhibition of flocculation by algal organic matter. The present results highlight the potential of these new type of nanocellulose-based flocculants for microalgae harvesting.

MATERIALES
Referencia del producto
Marca
Descripción del producto

Sigma-Aldrich
Ácido sulfúrico, 99.999%
Sigma-Aldrich
Diclorometano, anhydrous, ≥99.8%, contains 40-150 ppm amylene as stabilizer
Sigma-Aldrich
Alcohol etílico puro, 200 proof, anhydrous, ≥99.5%
Sigma-Aldrich
Pyridine, anhydrous, 99.8%
Sigma-Aldrich
Ácido sulfúrico, SAJ first grade, ≥95.0%
Sigma-Aldrich
Ácido sulfúrico, JIS special grade, ≥95.0%
Sigma-Aldrich
Alcohol etílico puro, 190 proof, ACS spectrophotometric grade, 95.0%
Sigma-Aldrich
p-Toluenesulfonyl chloride, ReagentPlus®, ≥99%
Sigma-Aldrich
4-(Bromomethyl)benzoic acid, 97%
Sigma-Aldrich
Pyridine, ≥99%
Supelco
Ethanol solution, 10 % (v/v) in H2O, analytical standard
Sigma-Aldrich
Alcohol etílico puro, 190 proof, meets USP testing specifications
Sigma-Aldrich
Sulfuric acid solution, 0.05 M
Sigma-Aldrich
p-Toluenesulfonyl chloride, reagent grade, ≥98%
Sigma-Aldrich
Etanol, JIS special grade, 94.8-95.8%
Sigma-Aldrich
Etanol, ≥99.5%, suitable for HPLC
Sigma-Aldrich
Sulfuric acid solution, 0.5 M
Supelco
Diclorometano, ≥99.9%
Sigma-Aldrich
Etanol, ≥99.5%
Supelco
Dichloromethane solution, contains 10 % (v/v) methanol
Sigma-Aldrich
Sulfuric acid solution, 0.1 M
Sigma-Aldrich
Diclorometano, JIS special grade, ≥99.0%
Sigma-Aldrich
Pyridine, JIS special grade, ≥99.5%
Sigma-Aldrich
Sulfuric acid solution, 1.5 M
Sigma-Aldrich
Diclorometano, SAJ first grade, ≥99.0%
Sigma-Aldrich
Ethanol solution, suitable for fixing solution (blood films)
Sigma-Aldrich
Diclorometano, suitable for HPLC, ≥99.9%, contains 40-150 ppm amylene as stabilizer
Sigma-Aldrich
Etanol, ≥99.5%, suitable for absorption spectrum analysis
Sigma-Aldrich
Etanol, JIS first grade, 94.8-95.8%
Sigma-Aldrich
Sulfuric acid solution, 0.01 M