Saltar al contenido
MilliporeSigma

Inherent organic compounds in biochar--Their content, composition and potential toxic effects.

Journal of environmental management (2015-04-08)
Wolfram Buss, Ondřej Mašek, Margaret Graham, Dominik Wüst
RESUMEN

Pyrolysis liquids consist of thermal degradation products of biomass in various stages of its decomposition. Therefore, if biochar gets affected by re-condensed pyrolysis liquids it is likely to contain a huge variety of organic compounds. In this study the chemical composition of such compounds associated with two contaminated, high-volatile organic compound (VOC) biochars were investigated and compared with those for a low-VOC biochar. The water-soluble organic compounds with the highest concentrations in the two high-VOC biochars were acetic, formic, butyric and propionic acids; methanol, phenol, o-, m- and p-cresol, and 2,4-dimethylphenol, all with concentrations over 100 μg g(-1). The concentrations of 16 US EPA PAHs determined by 36 h toluene extractions were 6.09 μg g(-1) for the low-VOC biochar. For high-VOC biochar the total concentrations were 53.42 μg g(-1) and 27.89 μg g(-1), while concentrations of water-soluble PAHs ranged from 1.5 to 2 μg g(-1). Despite the concentrations of PAHs exceeding biochar guideline values, it was concluded that, for these particular biochars, the biggest concern for application to soil would be the co-occurrence of VOCs such as low molecular weight (LMW) organic acids and phenols, as these can be highly mobile and have a high potential to cause phytotoxic effects. Therefore, based on results of this study we strongly suggest for VOCs to be included among criteria for assessment of biochar quality.

MATERIALES
Referencia del producto
Marca
Descripción del producto

Sigma-Aldrich
Fenol solution, BioReagent, Equilibrated with 10 mM Tris HCl, pH 8.0, 1 mM EDTA, for molecular biology
Sigma-Aldrich
Toluene-d8, 99.6 atom % D
Sigma-Aldrich
Fenol, ≥99%
Sigma-Aldrich
Fenol solution, BioReagent, Saturated with 0.01 M citrate buffer, pH 4.3 ± 0.2, for molecular biology
Sigma-Aldrich
Toluene-d8, 99 atom % D
Sigma-Aldrich
Diclorometano, anhydrous, ≥99.8%, contains 40-150 ppm amylene as stabilizer
Sigma-Aldrich
Tolueno, anhydrous, 99.8%
Sigma-Aldrich
Fenol, natural, 97%, FG
Sigma-Aldrich
Fenol, BioUltra, for molecular biology, TE-saturated, ~73% (T)
Sigma-Aldrich
Fenol, SAJ first grade, ≥98.0%
Sigma-Aldrich
Tolueno, SAJ first grade, ≥99.0%
Sigma-Aldrich
Fenol, puriss. p.a., ACS reagent, reag. Ph. Eur., 99.0-100.5%
Sigma-Aldrich
Fenol solution, ≥89.0%
Supelco
Dichloromethane solution, contains 10 % (v/v) methanol
Supelco
Diclorometano, ≥99.9%
Sigma-Aldrich
Fenol, for molecular biology
Sigma-Aldrich
Diclorometano, JIS special grade, ≥99.0%
Sigma-Aldrich
Tolueno, JIS special grade, ≥99.5%
Sigma-Aldrich
Toluene-d8, "100%", 99.96 atom % D
Sigma-Aldrich
Disulfuro de carbono, anhydrous, ≥99%
Sigma-Aldrich
Diclorometano, SAJ first grade, ≥99.0%
Supelco
Tolueno, HPLC grade, 99.8%
Sigma-Aldrich
Toluene-d8, anhydrous, 99.6 atom % D
Sigma-Aldrich
Fenol, puriss., ≥99.5% (GC), meets analytical specification of Ph. Eur., BP, USP, crystalline (detached)
Sigma-Aldrich
Fenol, BioXtra, ≥99.5% (GC)
Sigma-Aldrich
Fenol, contains hypophosphorous as stabilizer, loose crystals, ACS reagent, ≥99.0%
Sigma-Aldrich
Fenol, unstabilized, ReagentPlus®, ≥99%
Sigma-Aldrich
Diclorometano, suitable for HPLC, ≥99.9%, contains 40-150 ppm amylene as stabilizer
Sigma-Aldrich
Tolueno, JIS 300, for residue analysis, ≥99.8%
Sigma-Aldrich
Fenol, JIS special grade, ≥99.0%