Skip to Content
Merck
  • Quantitation of pregabalin in dried blood spots and dried plasma spots by validated LC-MS/MS methods.

Quantitation of pregabalin in dried blood spots and dried plasma spots by validated LC-MS/MS methods.

Journal of pharmaceutical and biomedical analysis (2015-03-15)
Nađa Kostić, Yannis Dotsikas, Nebojša Jović, Galina Stevanović, Anđelija Malenović, Mirjana Medenica
ABSTRACT

In this paper, novel LC-MS/MS methods for the determination of antiepileptic drug pregabalin in dried matrix spots (DMS) are presented. This attractive technique of sample collection in micro amount was utilized in the form of dried blood spots (DBS) and dried plasma spots (DPS). Following a pre-column derivatization procedure, using n-propyl chloroformate in the presence of n-propanol, and consecutive liquid-liquid extraction, derivatized pregabalin and its internal standard, 4-aminocyclohexanecarboxylic acid, were detected in positive ion mode by applying two SRM transitions per analyte. A YMC-Pack Octyl column (50mm×4.0mm, 3μm particle size) maintained at 30°C, was utilized with running mobile phase composed of acetonitrile: 0.15% formic acid (85:15, v/v). Flow rate was 550μL/min and total run time 2min. Established methods were fully validated over the concentration range of 0.200-20.0μg/mL for DBS and 0.400-40.0μg/mL for DPS, respectively, while specificity, accuracy, precision, recovery, matrix-effect, stability, dilution integrity and spot homogeneity were found within acceptance criteria. Validated methods were applied for the determination of pregabalin levels in dried blood and plasma samples obtained from patients with epilepsy, after per os administration of commercial capsules. Comparison of drug level in blood and plasma, as well as correction steps undertaken in order to overcome hematocrit issue, when analyzing DBS, are also given.

MATERIALS
Product Number
Brand
Product Description

Sigma-Aldrich
Chloroform, AR, contains 100 ppm amylene as stabilizer, ≥99.5%
Sigma-Aldrich
Sodium hydroxide solution, 0.1 N
Sigma-Aldrich
Hydrochloric acid solution, 0.1 N
Sigma-Aldrich
Hydrochloric acid, AR, 35-37%
Sigma-Aldrich
Hydrochloric acid, LR, 35-38%
Supelco
1-Propanol, suitable for HPLC, ≥99.5%
Sigma-Aldrich
1-Propanol, AR, ≥99.5%
Sigma-Aldrich
Chloroform, LR, contains 100 ppm amylene as stabilizer, ≥99%
Sigma-Aldrich
Chloroform, AR, contains 1-2% ethanol as stabilizer, ≥99.5%
Sigma-Aldrich
Sodium hydroxide, LR, flakes, ≥96%
Sigma-Aldrich
Sodium hydroxide, AR, pellets, ≥98.5%
Sigma-Aldrich
Sodium hydroxide solution, 5.0 M
Sigma-Aldrich
Sodium hydroxide, reagent grade, ≥98%, pellets (anhydrous)
Sigma-Aldrich
Sodium hydroxide, puriss. p.a., ACS reagent, K ≤0.02%, ≥98.0% (T), pellets
Sigma-Aldrich
Hydrochloric acid, meets analytical specification of Ph. Eur., BP, NF, fuming, 36.5-38%
Sigma-Aldrich
Sodium hydroxide, BioXtra, ≥98% (acidimetric), pellets (anhydrous)
Sigma-Aldrich
Hydrochloric acid, puriss., 24.5-26.0%
Sigma-Aldrich
Sodium hydroxide solution, purum, ≥32%
Sigma-Aldrich
Chloroform, contains 100-200 ppm amylenes as stabilizer, ≥99.5%
Sigma-Aldrich
Sodium hydroxide, reagent grade, 97%, powder
Sigma-Aldrich
Sodium hydroxide, puriss., meets analytical specification of Ph. Eur., BP, NF, E524, 98-100.5%, pellets
Sigma-Aldrich
Chloroform, ReagentPlus®, ≥99.8%, contains 0.5-1.0% ethanol as stabilizer
Sigma-Aldrich
Chloroform, puriss. p.a., reag. ISO, reag. Ph. Eur., 99.0-99.4% (GC)
Sigma-Aldrich
Chloroform, biotech. grade, ≥99.8%, contains 0.5-1.0% ethanol as stabilizer
Sigma-Aldrich
Hydrogen chloride solution, 4.0 M in dioxane
Sigma-Aldrich
Sodium hydroxide, reagent grade, 97%, flakes
Sigma-Aldrich
1-Propanol, ACS reagent, ≥99.5%
Sigma-Aldrich
1-Propanol, ≥99% (GC), purum
Sigma-Aldrich
Hydrogen chloride solution, 2.0 M in diethyl ether
Sigma-Aldrich
Chloroform, ACS spectrophotometric grade, ≥99.8%, contains 0.5-1.0% ethanol as stabilizer