Skip to Content
MilliporeSigma
  • Influence of ionic strength and substratum hydrophobicity on the co-adhesion of oral microbial pairs.

Influence of ionic strength and substratum hydrophobicity on the co-adhesion of oral microbial pairs.

Microbiology (Reading, England) (1996-09-01)
R Bos, H C van der Mei, H J Busscher
ABSTRACT

Co-adhesion between oral microbial pairs (i.e. adhesion of a planktonic microorganism to a sessile organism adhering to a substratum surface) has been described as a highly specific interaction, mediated by stereochemical groups on the interacting microbial cell surfaces, and also as a non-specific, critical colloid-chemical interaction. In a colloid-chemical approach, microbial co-adhesion is considered as an interplay between, amongst others, hydrophobic and electrostatic interactions. The aim of this paper was to determine the influence of ionic strength on the co-adhesion of Streptococcus oralis 34 to either Actinomyces naeslundii T14V-J1 or its mutant strain 5951 adhering to glass in a parallel-plate flow chamber. To this end, the ionic strength of the suspension was varied by the addition of KCl. Another aim was to investigate whether substratum hydrophobicity affected the co-adhesion between the organisms by allowing the sessile organisms (in this case the actinomyces) to adhere either to hydrophilic or to hydrophobic, dimethyldichlorosilane (DDS)-coated glass. The kinetics of co-adhesion of S. oralis 34 to the actinomyces decreased with increasing ionic strength, expressed as the ratio, chi, between the local and non-local initial deposition rates of the streptococci in the vicinity of, or far away from, the adhering actinomyces, respectively. In a stationary end-point of co-adhesion, ionic strength appeared not to be a determinant factor for the co-adhesion of S. oralis 34 with A. naeslundii 5951, either when the actinomyces were adhering to hydrophilic glass or to hydrophobic, DDS-coated glass. However, for S. oralis 34 co-adhering in a stationary end-point with A. naeslundii T14V-J1 in the high-ionic-strength (250 mM KCl) suspension, co-adhesion was far less on hydrophobic, DDS-coated glass than on hydrophilic glass. It is possible that the hydrophobic fibrils on A. naeslundii T14V-J1 bearing the lectin responsible for co-adhesion were immobilized in the latter case by adsorption to the hydrophobic substratum, making them less available for interaction with the streptococci.

MATERIALS
Product Number
Brand
Product Description

Supelco
Silanization solution I, ~5% (dimethyldichlorosilane in heptane), Selectophore
Sigma-Aldrich
Dichlorodimethylsilane, ≥99.5%
Sigma-Aldrich
Dichlorodimethylsilane, ≥98.5% (GC)
Sigma-Aldrich
Dichlorodimethylsilane, produced by Wacker Chemie AG, Burghausen, Germany, ≥99.0% (GC)