CWL901S03

Milligard^® LPB 1.2 µm, Cartridge

cartridge nominal length 10 in. (25 cm)

• Codice UNSPSC: 23151806

Proprietà

• Materiali: mixed cellulose esters (MCE) membrane ((treated for low protein binding)); polyester support; silicone O-ring
• Livello qualitativo: 400
• Sterilità: non-sterile
• Compatibilità con la sterilizzazione: autoclavable compatible; steam-in-place compatible
• Nome Commerciale: Milligard^®
• Caratteristiche: hydrophilic
• Produttore/marchio commerciale: Milligard^®
• tecniche: prefiltration: suitable
• Lunghezza: 10 in.
• Larghezza: 2.9 in.
• Lunghezza nominale della cartuccia: 10 in. (25 cm)
• Dimens. filtro: 10 in.
• Superficie filtrante: 0.8 m²
• Impurezze: <0.5 EU/mL USP bacterial endotoxins (LAL test, sample aqueous extraction)
• Matrice: Milligard^® LPB
• Dimensione pori: 1.2 μm nominal pore size; 1.2 μm pore size
• Codice cartuccia: Code 0

Descrizione

Descrizione generale

Cartridge Type: Liquid

Device Configuration: Cartridge

Filter Grade: Low Protein Binding MILLIGARD^® Media

Caratteristiche e vantaggi

Format: Single Layer

Nota sulla preparazione

This product was manufactured with a media combination which meets the criteria for a "non-fiber releasing" filter as defined in 21 CFR 210.3 (b) (6).

Risultati analitici

Gravimetric Extractables: The extractables level was ≤250 mg per 10-inch cartridge after a 5 L flush and 24 hours in water at controlled room temperature.   

Altre note

Directions for Use:

• Organism Retention: Microorganism
• Mode of Action: Filtration (size exclusion)
• Application: BioProcessing
• Intended Use: Reduction or removal of microorganism/bioburden
• Instructions for Use: Please refer installation and wetting sections of OPTISCALE^® -25 user guide and introduction section of Mixed cellulose esters Tech Brief
• Storage Statement: Please refer Mixed cellulose esters Tech Brief
• Disposal Statement: Dispose of in accordance with applicable federal, state and local regulations

These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.

Note legali

MILLIGARD is a registered trademark of Merck KGaA, Darmstadt, Germany

OptiScale is a registered trademark of Merck KGaA, Darmstadt, Germany