Saltar al contenido
Merck

Distribution and Photochemistry of Polycyclic Aromatic Hydrocarbons in the Baotou Section of the Yellow River During Winter.

Archives of environmental contamination and toxicology (2015-04-04)
Qi Zhang, Guoxia Pei, Gengyun Liu, Hanqing Li, Lihui Gao
RESUMEN

In this study, ice and water samples were collected from seven sites along the Baotou section of the Yellow River during winter 2013. Total polycyclic aromatic hydrocarbon (PAH) concentrations in the ice and in the water under the ice ranged from 21.3 to 59.4 ng L(-1), and from 38.3 to 222.4 ng L(-1), respectively. The average concentration in water under the ice was approximately 2.5 times greater than the average concentration in the ice phase. Four-ring PAHs dominated and accounted for 68.2 and 76.0 % of the total PAHs in ice and water, respectively. PAH concentrations were highest at sampling site S2 and were also relatively high at sites S4 and S5. PAH sources in ice and in water under the ice were similar. Three components were selected to represent the coal-combustion sources of PAHs. Because it was the main pollutant, and its concentrations were the highest, we examined the photodegradation behavior of fluoranthene and investigated the effects of light-sensitive materials (H2O2, acetone, and sediment) on fluoranthene photodegradation in the ice phase. Results showed that low H2O2 concentrations promoted photoconversion in the initial stage of the reaction and that degradation rates decreased later in the reaction. Likewise, high H2O2 concentrations promoted photoconversion. As acetone concentrations increased, the rates of fluoranthene-degradation decreased. Sediments may also have decreased the degradation rate of fluoranthene.

MATERIALES
Referencia del producto
Marca
Descripción del producto

Sigma-Aldrich
Peróxido de hidrógeno solution, 30 % (w/w) in H2O, contains stabilizer
Sigma-Aldrich
Cloruro de sodio, for molecular biology, DNase, RNase, and protease, none detected, ≥99% (titration)
Sigma-Aldrich
Sodium chloride solution, 5 M in H2O, BioReagent, for molecular biology, suitable for cell culture
Sigma-Aldrich
Sodium chloride solution, 0.9% in water, BioXtra, suitable for cell culture
Sigma-Aldrich
Cloruro de sodio, BioReagent, suitable for cell culture, suitable for insect cell culture, suitable for plant cell culture, ≥99%
Sigma-Aldrich
Cloruro de sodio, BioXtra, ≥99.5% (AT)
SAFC
Sodium chloride solution, 5 M
Sigma-Aldrich
Pyrene, 98%
Sigma-Aldrich
Benzo[a]pyrene, ≥96% (HPLC)
Sigma-Aldrich
Naphthalene, 99%
Sigma-Aldrich
Sodium chloride solution, BioUltra, for molecular biology, ~5 M in H2O
Sigma-Aldrich
Cloruro de sodio, BioUltra, for molecular biology, ≥99.5% (AT)
Sigma-Aldrich
Cloruro de sodio, 99.999% trace metals basis
Sigma-Aldrich
Sodium chloride solution, 5 M
Sigma-Aldrich
Fluorene, 98%
Sigma-Aldrich
Phenanthrene, 98%
Sigma-Aldrich
Anthracene, ReagentPlus®, 99%
Sigma-Aldrich
Cloruro de sodio, meets analytical specification of Ph. Eur., BP, USP, 99.0-100.5%
Sigma-Aldrich
Peróxido de hidrógeno solution, 34.5-36.5%
Sigma-Aldrich
Anthracene, reagent grade, 97%
Sigma-Aldrich
Pyrene, puriss. p.a., for fluorescence, ≥99.0% (GC)
Sigma-Aldrich
Naphthalene, suitable for scintillation, ≥99%
Sigma-Aldrich
Fluoranthene, 98%
Sigma-Aldrich
Decafluorobiphenyl, 99%
Sigma-Aldrich
Cloruro de sodio, BioPerformance Certified, ≥99% (titration), suitable for insect cell culture, suitable for plant cell culture
Sigma-Aldrich
Benzo[a]anthracene, 99%
Sigma-Aldrich
Acenaphthylene, 99%
Sigma-Aldrich
Cloruro de sodio, AnhydroBeads, −10 mesh, 99.999% trace metals basis
Sigma-Aldrich
Sodium chloride-35Cl, 99 atom % 35Cl
Sigma-Aldrich
Sodium chloride solution, 0.85%