95102433

BEAS-2B Cell Line human

• Code UNSPSC : 41106514

Propriétés

• Source biologique: human lung
• Description: Human bronchial epithelium, normal
• Forme: liquid
• Mode de croissance: Adherent
• Caryotype: Not specified
• Morphologie: Epithelial-like
• Produits: Not specified
• Récepteurs: Not specified
• Technique(s): cell culture | mammalian: suitable
• Conditions d'expédition: dry ice
• Température de stockage: −196°C

Description

Origine de la lignée cellulaire

Human bronchial epithelium, normal

Description de la lignée cellulaire

BEAS-2B cells were derived from normal bronchial epithelium obtained from autopsy of non-cancerous individuals. Cells were infected with a replication-defective SV40/adenovirus 12 hybrid and cloned. Squamous differentiation can be observed in response to serum. This ability can be used for screening chemical and biological agents inducing or affecting differentiation and/or carcinogenesis. The cell line has been applied for studies of pneumococcal infection mechanisms. BEAS-2B was described to express keratins and SV40 T antigen. Subculturing the cells before confluency is necessary as confluent cultures rapidly undergo squamous terminal differentiation.

Application

BEAS-2B Cell line has been used to study differentiation of squamous cells and effect of biological and chemical agents on differentiation.

Profil d'ADN

STR-PCR Data: Amelogenin: X,Y
CSF1PO: 9,12
D13S317: 13
D16S539: 12
D5S818: 12,13
D7S820: 10,13
THO1: 7,9.3
TPOX: 6,11
vWA: 17,18

Milieu de culture

BEGM, also known as LHC-9 with modification (available from Clonetics Corporation, CC3171 (BEBM) plus additives CC4175 or BEGM Bullet Kit, CC3170); Note: Additives supplied contain gentamycin which has been omitted for culture at ECACC; media is serum-free.

Procédure de repiquage

Passage sub-confluent cultures using 0.25% trypsin or trypsin/EDTA. Incubate at room temperature for 5-10 min until cells detach. Add fresh medium and disperse cells, centrifuge and resuspend pellet in medium. Seed into new flasks at 1500 to 3000 cells per cm². Flasks have to be precoated with a mixture of 0.01 mg/ml fibronectin, 0.03 mg/ml collagen and 0.001 mg/ml bovine serum albumin dissolved in BEGM. Add mixture at ratio of 0.2 ml per cm² surface area. Incubate at 5% CO₂, 37°C for at least 6 hours at 37oC. Remove excess fluid and allow flasks to dry by incubating at 37oC overnight, leaving the caps loose. Prior to addition of cells wash flask three times with PBS. Note: BEGM medium is almost serum-free, therefore trypsin inhibitor is essential. Add an equal or greater volume of trypsin inhibitor as trypsin used before, centrifuge and reseed cells in collagen coated flasks using culture medium.

Autres remarques

Additional freight & handling charges may be applicable for Asia-Pacific shipments. Please check with your local Customer Service representative for more information.
Cultures from HPA Culture Collections and supplied by Sigma are for research purposes only. Enquiries regarding the commercial use of a cell line are referred to the depositor of the cell line. Some cell lines have additional special release conditions such as the requirement for a material transfer agreement to be completed by the potential recipient prior to the supply of the cell line.
Please view the Terms & Conditions of Supply for more information.

Clause de non-responsabilité

Ce produit, destiné à la recherche scientifique, est soumis à une réglementation spécifique en France, y compris pour les activités d'importation et d'exportation (Article L 1211-1 alinéa 2 du Code de la Santé Publique). L'acheteur (c'est-à-dire l'utilisateur final) est tenu d'obtenir une autorisation d'importation auprès du Ministère français de la Recherche, mentionné à l'article L1245-5-1 II du Code de la Santé Publique. En commandant ce produit, vous confirmez détenir l'autorisation d'importation requise.

Informations sur la sécurité

• Code de la classe de stockage: 10 - Combustible liquids
• Classe de danger pour l'eau (WGK): WGK 3
• Point d'éclair (°F): Not applicable
• Point d'éclair (°C): Not applicable