Direkt zum Inhalt
Merck

Treatment of a simulated phenolic effluent by heterogeneous catalytic ozonation using Pt/Al2O3.

Environmental technology (2013-03-28)
Ana S Fajardo, Rui C Martins, Rosa M Quinta-Ferreira
ZUSAMMENFASSUNG

Non-catalytic and catalytic ozonation over Pt/Al2O3 were considered in the treatment of a synthetic effluent composed of six phenolic acids usually present in olive mill wastewaters. In both processes the medium pH affected the rate of ozone decomposition and the formation of hydroxyl radicals. The optimum values were achieved for the catalytic system under pH 7 with 93.0 and 47.7%, respectively, of total phenol content and chemical oxygen demand (COD) removal, after 120 minutes of reaction. For pH 3, the catalytic ozonation followed a free radical pathway perceived by the presence of radical scavengers. No significant structural differences were observed between the fresh and used solid catalyst in X-ray diffraction analysis. Aluminium leaching behaviour was also evaluated at the end of each experiment. Moreover, a sequence of feed-batch trials involving the catalyst reutilization exhibited almost constant activity during the operation time. Eco-toxicological tests were performed for both processes, revealing that the treated effluent still presents some ecological impact, although it is lower than that for the raw wastewater.

MATERIALIEN
Produktnummer
Marke
Produktbeschreibung

Sigma-Aldrich
Aluminiumoxid, activated, basic, Brockmann I
Sigma-Aldrich
Aluminiumoxid, activated, neutral, Brockmann I
Sigma-Aldrich
Aluminiumoxid, powder, 99.99% trace metals basis
Sigma-Aldrich
Aluminiumoxid, activated, acidic, Brockmann I
Sigma-Aldrich
Aluminiumoxid, nanopowder, <50 nm particle size (TEM)
Sigma-Aldrich
Aluminiumoxid, nanoparticles, <50 nm particle size (DLS), 20 wt. % in isopropanol
Sigma-Aldrich
Aluminiumoxid, Corundum, α-phase, -100 mesh
Sigma-Aldrich
Platin, gauze, 100 mesh, 99.9% trace metals basis
Sigma-Aldrich
Aluminiumoxid, nanopowder, 13 nm primary particle size (TEM), 99.8% trace metals basis
Sigma-Aldrich
Aluminiumoxid, fused, powder, primarily α-phase, -325 mesh
Sigma-Aldrich
Platinschwarz, black, powder, ≤20 μm, ≥99.95% trace metals basis
Sigma-Aldrich
Aluminiumoxid, 99.997% trace metals basis
Sigma-Aldrich
Platin, wire, diam. 1.0 mm, 99.9% trace metals basis
Sigma-Aldrich
Aluminiumoxid, pore size 58 Å, ~150 mesh
Sigma-Aldrich
Platin, foil, thickness 0.025 mm, 99.9% trace metals basis
Sigma-Aldrich
Aluminiumoxid, Type WN-6, Neutral, Activity Grade Super I
Sigma-Aldrich
Aluminiumoxid, nanoparticles, 30-60 nm particle size (TEM), 20 wt. % in H2O
Sigma-Aldrich
Platin, wire, diam. 0.5 mm, 99.99% trace metals basis
Sigma-Aldrich
Platin, powder, 99.995% trace metals basis
Sigma-Aldrich
Aluminiumoxid, fused, powder, primarily α-phase, 100-200 mesh
Sigma-Aldrich
Platin, wire, diam. 0.25 mm, 99.9% trace metals basis
Sigma-Aldrich
Platin, wire, diam. 0.5 mm, 99.9% trace metals basis
Sigma-Aldrich
Platin, nanopowder, <50 nm particle size (TEM)
Sigma-Aldrich
Platin, gauze, 52 mesh, 99.9% trace metals basis
Sigma-Aldrich
Aluminiumoxid, nanowires, diam. × L 2-6 nm × 200-400 nm
Sigma-Aldrich
Aluminumoxid, mesoporös, MSU-X (wormhole), average pore size 3.8 nm
Sigma-Aldrich
Aluminiumoxid, single crystal substrate, <0001>
Sigma-Aldrich
Aluminiumoxid, activated, neutral, Brockmann I, free-flowing, Redi-Dri
Sigma-Aldrich
Platin, foil, thickness 0.05 mm, 99.99% trace metals basis
Sigma-Aldrich
Platinschwarz, fuel cell grade, ≥99.9% trace metals basis